Return to Return to

Enter your email for Updates


Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - younggeezer

Pages: [1]
9N,2N,8N, Ford Tractors / 9N carb
« on: September 04, 2009, 07:57:56 AM »
I have a 9N that has been sitting for a few years, new points & condenser and carb kit got it running, but it is not running right.  I need to manipulate the choke to keep it running, it does seem to run better when the when it is under a load.  Bottom line it I am tired of fooling with the old carb.  Iím thinking about buying a new Zenith carb.  Does anyone have any pros or cons about this swap?

9N,2N,8N, Ford Tractors / Re: Electronic Ignition
« on: April 15, 2009, 12:40:01 PM »
I installed mine.  Run the one wire from the module directly to the ignition switch, do not go through the resistor.  A wire from the top of the coil grounds to any good location on the frame. 

9N,2N,8N, Ford Tractors / Re: 9N Just Wont Start
« on: April 15, 2009, 12:35:50 PM »
UPDATE!  Installed a new electronic ignition module on the tractor, it now has fire!!  But now the carb is not flowing right.  New project!.

9N,2N,8N, Ford Tractors / Re: Electronic Ignition
« on: March 12, 2009, 07:47:19 PM »
I sure wish someone would answer you.  I ordered mine kit yesterday so I'd like to know what to expect!!

9N,2N,8N, Ford Tractors / Re: 9N Just Wont Start
« on: January 31, 2009, 12:32:52 AM »
It does have fire to the coil, but no fire to the plugs??

9N,2N,8N, Ford Tractors / 9N Just Wont Start
« on: January 15, 2009, 08:51:09 PM »
I have a 9N that I replaced the manifold due to the exhaust leaking.  Since the replacement, the tractor will not start.  I have installed and new battery, new ignition switch, points, condenser, cap, rotor, spark plugs and resister.  the tractor will turn over, but it will not start.  The tractor is still 6v.  Ya got any ideas what to look for or try now?

Pages: [1]