Return to 9NFord.com Return to 
WisconsinOutdoor.com

Enter your email for 9NFord.com Updates

Preview

Author Topic: 9n shifter problem  (Read 3358 times)

edw.p24

  • Newbie
  • *
  • Posts: 1
  • Karma: 0
    • View Profile
9n shifter problem
« on: May 20, 2010, 06:03:15 AM »
I recently purchased a 1942 9n knowing nothing about tractors and little about mechanics in general. Shortly after buying and a little use, the shifter lever started moving up and down in the socket. As I inspected it, I saw a small pin in the base of the shifter where it goes into the housing. The pin is in a round recess that I would guess holds a ball or bearing with a hole to receive the pin and hold the whole lever into place. Since the dust cover/boot is either wrong or installed wrong, I am guessing the ball/bearing fell out and is gone forever. I have a new boot on the way, but how do I replace this ball or whatever to fix the problem? Or am I just completely wrong about how the lever is held into place? I have a manual, but it is not clear. Can anybody help?

42ford9n

  • Newbie
  • *
  • Posts: 9
  • Karma: 0
    • View Profile
Re: 9n shifter problem
« Reply #1 on: August 09, 2010, 07:06:49 PM »
my shifter stick moves up and down too. but it works fine and i think its supposed to move up and down a little bit. as long as you cant pull it out i think you are fine. I've used my 42 ford 9n tractor since i was 10 and they are a joy.