Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - nj9n

Pages: [1]
1
9N,2N,8N, Ford Tractors / Re: My first 9n and it won't start!!
« on: March 22, 2007, 02:40:50 PM »
It has a old looking coil. I hope its its a 12v, I did'nt convert it myself. I broke down and orderd a new one, hopefully its at fault. Compression lookes good (it turned over a few times and sounds good), but i did'nt check it or remove any plugs. I used a plug laying around to check the spark. It has "new" looking plugs in it. I will check them better when I put the new coil in. Thanks for the help.

2
9N,2N,8N, Ford Tractors / My first 9n and it won't start!!
« on: March 21, 2007, 01:36:26 PM »
I just got my first 9N- 1941 that has been converted to 12v. It is getting gas, I took the carb appart and it was clean. (I touched it up and evrything works good) It was not giving any spark to the plugs, so I started to clean all the conections. The wire from the resistor to the coil was cleaned and now it has spark. Still won't start. The spark is red/orange and not very good. I don't want to start replacing parts blindly till it works, but I suspect the coil. Can anyone offer me advice on my situation? Thank you.

Pages: [1]